amplifying circuit造句

• An analysis of how to distinguish feedback patterns in amplified circuits
  放大电路中反馈类型判别方法的分析
• Small - signal pre - amplifying circuit for microwave - induced thermoacoustic tomography
  微波热声成像弱信号预放大电路
• The application of slc800 linear optoelectronic coupler in isolated amplifying circuit
  800线性光电偶合器在隔离放大电路中的应用
• The analysis on amplitude frequency characteristics of picture intermadiate frequency amplify circuit of colour television
  彩电图像中放电路幅频特性分析
• The thesis offers apd signal amplify circuit chart and controlling time - series logic circuit principle chart bearing practical applied value
  给出了apd信号放大电路和控制时序逻辑电路原理图。
• The circuits which signals transit in , including amplifying circuit , filter circuit , export circuit , etc were placed in the same chapter
  信号通路中包括信号发生放大电路、滤波电路、整形电路和输出电路。
• Mixing - signal stimulation method can enhance dissipation of bipolar transistor evidently , especially first cascade amplifying circuits
  理论分析和实践结果都表明，本文所提出的方法能有效地改善有源低热器件的红外热图像。
• In mainly contains photoelectric converting and pre - amplifying circuits , lcd and keyset interface circuits and data storing circuits based on i2c bus
  主要包括光电转换和信号前置放大电路、液晶屏和键盘接口电路和基于i ~ 2c总线的数据存储器电路。
• After that , the thesis studies and designs the voltage stabilized source , amplifying circuit , single - chip - computer hardware and its software of the torque sensor
  研究设计了智能扭矩扳手检定仪的稳压电源、放大电路、单片机系统硬件电路和测量软件。
• Here this article describes and analyses the general charts of several multi - loop negative feedback amplifying circuits and the general formula of the " closed - loop " amplifying ( transfer function )
  给出几种多环负反馈放大电路的一般方框图和“闭环”增益（传输函数）一般表达式，并浅析。
• The simulation results reveal that the method is effective . finally , in order to improve the precision , amplifying circuit and low pass filter are designed based on theoretical analysis
  最后,本文从提高系统精度的角度出发,在理论分析的基础上,设计出放大电路和低通滤波电路,并利用pspice软件对电路进行了仿真。
• Lastly , we establish the digital control system which includes signal process circuit , a / d . pwm circuit and amplify circuit , etc . the problem of unsuitable time order between dsp and counter 8254 - 2 is solved in this paper
  第三，建立了以dsp为核心包括信号预处理、 a d转换、脉宽调制( pwm ) 、功放电路在内的数字控制系统。
• The analysis of the weak signal circuit , amplifying circuit of the signal and power circuit in the thermal conductivity detector has been done , and the characteristic of the circuits with the rhenium tungsten filament is designed
  针对气相色谱热导检测器的弱信号失真和电源不稳定问题，研究与设计热导检测器的弱信号测量电路、信号放大电路以及电源电路。
• The mcml circuits output low swing signal , while it is necessary to amplify it so as to interfacing the binary signal . an low - swing - signal - amplifying circuit is proposed in this dissertation to realize the interface
  由于mcml电路输出的是小摆幅信号，论文提出了一个三值放大电路，将三值mcml电路的输出进行放大，以便进一步转换，实现和二值信号的接口。
• The amplitude discrimination circuit , the filter circuit and the amplifying circuit are designed to transform ac analog signal that the eddy current sensor output to dc analog signal , thus , the dc analog signal can be received by ad converter
  传感器输出的测量信号是中频的交流模拟信号，在下位机系统设计了鉴幅、滤波、放大电路将测量信号转化为模数转换器可以接受的直流信号。
• Two methods for acquiring signals out of the conductance - linearised seasor have been presented with comparison of the error analysis . the superlority of applying “ integrated operational amplified circuit ” has been concluded and the method could be broadly adopted in practice
  出了电导线性化标定的传感器信号的两种采集方法，进行了误差分析比较，并得出了利用“集成运放方法”的优越性
• Capacity variation of two capacitance of measuring membrance is also proportion to pressure . by amplified circuit the would be linearly converted to 420 ma dc two wire system current voltage or digital hart output signal high - speed addressable remote sender data road
  测量膜片的两电容固定极板的被放大电路线性地转换成420ma dc的二线制电流电压或数字hart高速可寻址远程发送器数据公路输出信号。
• In the course of exploiting the system hardware , we adopt the low frequency sine wave excitation technology whose frequency is alterable , and scheme out the new signal conversion & amplifying circuit , the new lcd circuit and the new system anti - interference circuit
  在系统硬件电路的开发中，我们采用了频率可调的低频正弦波励磁技术，并设计出新颖的信号转换放大电路、液晶显示电路和系统抗干扰电路。
• The thesis analyses the problems on the noise of apd photoelectric receiving system . author designs apd laser signal receiving system circuits , front amplify circuit , controlling time - series logic circuits , dc / dc transform circuits . and takes apd bias voltage fuzzy control
  分析了apd光电接收系统的噪声问题，并对apd激光信号接收系统电路、前置放大电路、控制时序逻辑电路、 dc / dc变换电路进行了设计，采取了apd偏压模糊控制。